Welcome to the Specialist Supplier & Manufacturer to the Power Transmission Drives Industry
Copyright remains the property of Lakehurst Limited
Information Bar -
American Standard Nickel Plated Carbon Steel Roller Chains
Nickel Plated Roller Chains to ANSI B 29.1/Din 8188 Stds
|1/2 x 5/16"
Waisted Side Plate
Straight Side Plate
Straight Side Plate
These are the main sizes of Chains that can be supplied Nickel plated although not all, as some of our manufacturing partners offer a plating service on most of the chains they produce subject to a minimum production quantity.
So if you can not find what you are looking for here please contact or Sales Department with your requirement?
Plated Chains can be supplied in two formats: All parts Plated before Assembly - which offer the full protection of the plating! or after assembly usually cheaper but they do not provide Full protection (This type should only be considered for cosmetic reasons only)
Extended Pins: Plain & Grooved?
Attachment Plates: K1.K2, M1, M2?
Connecting Links: Both Spring Clip type & Cotter Pin type dependent on Pitch Size?
Offset/Crank Link: Single Pitch type only!
Std Box length: 5meters, 10Ft
Cut lengths: to order
Precision Roller Chains: as the company offers a combined range, that is produced by a number manufacturers from arounf the World, it has adopted the following Quality Standards:-
1- All chains have been produced in plant that is Certified to ISO 9001
2- Chains covered by the ISO 606R Standard, will conform to this Standard of Specification and Quality
3- For chains not covered by ISO606R, then we have adopted the appropriate Din 8187 or Din 8188 or Ansi B 29.1 of Specification and Quality Standard.
4- Work standard chains not covered by the above standards will conform to the appropriate Manufacturer's Standard.
Only listed here are the base designations for these chains, although there is a number of prefixes that designate the different types! (For a full listing please use the company's Product Search Service, see below).
This New feature is there to provide useful links to other pages, further information and Tips you may find of interest?
Be Careful when replacing drive wheel for the C2040, C2050, C2060, C2080 & C2100 chains, as well as drive wheel cut to the correct Pitch Size. It is also possible to use the Shorter Pitch Standard Ansi Sprockets by driving off every other tooth see links above? However we would strongly recommend that you obtain the Outside Diameter and number of teeth to confirm which type is fitted.?
Parts & Tools:
Links to Related Products: